A few questions. #412
Replies: 4 comments 11 replies
-
ScottStevens wrote at Oct 31 2016 02:29:43 UTC: Hey jeomaster , I have PufferPanel working on Ubuntu 16.04 with a little bit of editing to point to the correct PHP directories. Apart from that it has worked perfectly fine for me. Also, your FQDN should be whatever the full hostname for the server is. Example: www.example.com. If you do not own a domain you can set this as the IP of the server. I personally edit the Node installer to use Oracle's Java 8 rather than openjdk. That is completely optional however. EDIT: I would refer to the following page to help with node installations: http://scales.pufferpanel.com/docs/getting-started |
Beta Was this translation helpful? Give feedback.
-
ScottStevens wrote at Oct 31 2016 02:29:43 UTC: It should point to the public IP of the node not PufferPanel (if the servers are separate). Apart from that there shouldn't be any problems. As a last resort you could restart the whole server. |
Beta Was this translation helpful? Give feedback.
-
ScottStevens wrote at Oct 31 2016 02:29:43 UTC: It should point to the server's IP - in this case yes, 192.168.1.186. From there you can forward the port from your router to the server for it to be publicly accessible. The Server can only bind to a local IP address (or more specifically the interface which is likely eth0) - it cannot bind to any other addresses unless it is assigned to the interface. |
Beta Was this translation helpful? Give feedback.
-
PacksGamingHD wrote at Oct 31 2016 02:29:43 UTC: you'd be better off installing puffer panel on ubuntu 14.04. or ubuntu 16.04 do not install it on 15.10 as its unsupported. i can install it for you on 16.04 if you want |
Beta Was this translation helpful? Give feedback.
-
jeomaster wrote at Oct 31 2016 02:29:43 UTC:
I am new and lost. I have been told by one person that PufferPanel doesn't work on Ubuntu 16.10. Another guy told me that Ubuntu 15.10 is unsupported and I should use 16.10. Which is correct??? Also, when I installed puffer panel I got very confused at the node stage. Can anybody help me figure out what to put in the inputs, I am mainly unsure about the FQDN input. Thanks a ton!
Beta Was this translation helpful? Give feedback.
All reactions